CLASS 4 RUBBER GLOVE KIT

OEL Rubber Glove Warranty

All necessary company safety practices for use of rubber products should be followed and assigned per company/corporation safety policy/program. OEL Worldwide Industries does not assume liability for the improper care and/or use of rubber products. Visual inspections and routine testing should be performed per necessary standards.

This warranty is exclusive and in lieu of all other warranties, whether oral, written, express, implied, or statutory. No Implied or Statutory Warranties of Merchant Ability of Fitness for a Particular Purpose Will Apply. OEL Worldwide Industries shall not be liable for any loss or damage, direct, indirect, incidental, or consequential, arising out of the use of – or the inability to use – the product. Before using, users shall determine the suitability of the product for the intended use, and users assume all risk and liability whatsoever in connection therewith. Therefore, users should make careful analysis of the use for which these products are purchased. It will be the users’ responsibility to determine whether these products will adequately provide protection in the environment in which they are to be used. OEL Worldwide Industries cannot anticipate all conditions under which this information and its products, or the products of other manufacturers in combination with its products, may be used. Users are advised to make their own tests to determine the suitability of each product or product combination for their own purposes.

OEL Worldwide Industries warranties follow ASTM D120. It reads: 12.1 The manufacturer or supplier shall replace, without charge to the purchaser, unused gloves which, at any time within a period of nine (9) months from the date of initial delivery of the shipment to the purchaser or his designee, fail to pass the tests in this specification. This guarantee will be binding on the manufacturer or supplier only if the gloves have been properly stored and have not been subjected to more than an original acceptance test and one retest. 12.2 Any acceptance test made by the purchaser or the purchaser’s designee shall be performed within the first two (2) months of the guarantee period unless otherwise specified. NOTE 3 — Proper storage means that gloves are stored right side out, not distorted, and not stored directly above or in proximity to steam pipes, radiators, or other sources of artificial heat, or exposed to direct sunlight or other sources of ozone. It is desirable that the ambient storage temperature shall not exceed 35°C (95°F).